search

DVE2000 / Dogbone

A Fusion360 addin that creates dogbone joints for wood joinery.
148 stars 43 forks source link

Can't find Dogbone icon? #44

Closed tiktuk closed 3 years ago

tiktuk commented 5 years ago

Hi, from where should Dogbone be run? I can't see the icon anywhere after installing and running the Addin. I only managed to run it from the command box (the one that shows up when pressing "S").

pludikar commented 5 years ago

Hi @tiktuk,

Sorry for the delay in responding - it's been a busy day.

You'll find the addin icon under the SOLID tab at the right hand end of the CREATE panel, in the DESIGN workspace. You'll also find the dogbone command under the CREATE pulldown at the very bottom. I hope you find the addin useful. See here: image.

Regards Peter

tiktuk commented 5 years ago

Sorry for the delay in responding - it's been a busy day.

You'll find the addin icon under the SOLID tab at the right hand end of the CREATE panel, in the DESIGN workspace. You'll also find the dogbone command under the CREATE pulldown at the very bottom. I hope you find the addin useful.

Thank you! It is very useful indeed, thanks a lot for your work ☺️ .

Tuk