video output active in standby

[GoogleCodeExporter]

What steps will reproduce the problem?
1.Put the system into standby.
2.
3.

What is the expected output? What do you see instead?
should cut video. video remains active

What version of priiloader are you using? On what ios/system menu?
0.2(r30) cIOS 60 4.1U

Do you have any IOS patches installed? (if so which ios and what patch?)
most of them..... shouldn't matter works without preloader or priiloader.

What are your wii system menu settings
settings are default with burn in reduction and widescreen active.

Original issue reported on code.google.com by MKBecht...@gmail.com on 7 Dec 2009 at 9:27

[GoogleCodeExporter]

and how long do you wait, and does it still happen when you remove a DVD from 
the drive

cause with DVD in the drive it could take a while...

Original comment by dac...@gmail.com on 7 Dec 2009 at 3:32

[GoogleCodeExporter]

I'll take a look. I'll leave it with the disc in until it either turns off or 10
minutes go by which ever comes first. I'll also check if the disc being in the 
drive
has anything to do with it. Sorry missed a few points on it was up a little 
late...

Original comment by MKBecht...@gmail.com on 7 Dec 2009 at 5:32

[GoogleCodeExporter]

ok I took a look I let it sit in standby with the disc in and after over ten 
minutes
it didn't cut the video signal. I removed the disc and even all my usb devices 
memory
cards ect. and still five minutes later it's still active. I'm going to install 
an
original system menu IOS and system menu wad and then priiloader and see if it 
was
perhaps the cIOS.

Original comment by MKBecht...@gmail.com on 7 Dec 2009 at 6:03

[GoogleCodeExporter]

ok last comment for now. I have taken a deeper look into the whole thing. 
reinstalled
system menu IOS 60 and priiloader. I disabled all the system menu hacks from 
start
patch and priiloader settings. I removed the disc and all other items from the 
wii
including the usbGecko the USB hard drive, Gamecube controllers GC memory card. 
even
the SD card and Did a full power cycle of the system. After all this still the 
video
feed stays open while the system is in standby. It's been at least a five 
minute wait
for each test.

Original comment by MKBecht...@gmail.com on 7 Dec 2009 at 6:29

[GoogleCodeExporter]

Ok I have completely tested starting with the fresh unmodified system menu 
install
with an untouched IOS 60 I then installed bootmii boot2 and tried only to note 
that
the system went to standby and cut the video feed. I then installed Priiloader 
and
then power off the system and the video feed stays open........ I then 
uninstalled
priiloader and chose the shutdown option in the HBC and the video feed remained 
open
just as with priiloader...... I turned it off and then on and put the system in
standby the video feed was cut........

So yeah oddly the HBC's shutdown function has the same issue for me. Any idea 
as to
what this might be? perhaps reinstall all the patched IOS's with unpatched 
versions
and see if this has any difference?

Original comment by MKBecht...@gmail.com on 7 Dec 2009 at 6:53

[GoogleCodeExporter]

closed as its not priiloader related obviously

reinstall the ios hbc is using...if that isn't 60 that is

Original comment by dac...@gmail.com on 7 Dec 2009 at 7:01

• Changed state: WontFix