Feature Request: Multi fan compensation for MPC heating model

DangerKlippers / danger-klipper

Klipper but... Dangerous

GNU General Public License v3.0

256 stars 88 forks source link

Feature Request: Multi fan compensation for MPC heating model #321

Open OverkillFPV opened 5 months ago

OverkillFPV commented 5 months ago

Like most people, i run a CPAP cooler as well as aux parts cooling and interestingly and i suppose not suprisingly the rscs aux fan provides more cooling than the CPAP. (22.2W for the the CPAP and 26.8W for the RSCS). allowing a list of fans would help improve the effectiveness of the heater model as far as i understand. This is assuming that i am not suggesting an already possible feature.

YanceyA commented 5 months ago

How are the fans run during print?

Exclusively, one one fan at a time
In series, both fans run the same % speed always.
Independently, the fans are operated at different speeds

OverkillFPV commented 5 months ago

Both fans are run at independent speeds based off the filament settings, the cpap toolhead fan runs dynamically based off overhangs and speeds but the RSCS fan is typically a fixed speed set in the slicer.