search

DctrlVan / dctrl-admin

Management System
MIT License
3 stars 2 forks source link

Hardware: Connect Pi to Mag Lock controller. #44

Closed ghost closed 6 years ago

ghost commented 7 years ago

The 3 volt trigger on the rasp pi can be connected to the Control- and Control+ on the mag lock power supply - this allows a rasp pi to be installed beside the current installation. Next step is to run a network wire & five volt power / up to the door.

dctrlcommons commented 7 years ago

Now need to set up (2) new rasp pi's and sd cards with arch Linux and then configure for network, ssh, install node, and get the dctrl-fobtap repo running again.

dctrlcommons commented 7 years ago

First installation from: https://archlinuxarm.org/platforms/armv6/raspberry-pi : these instructions boot into rootfs (similar to safe mode)