search

DeBesten / open9x

Automatically exported from code.google.com/p/open9x
0 stars 0 forks source link

Rotary encoder navigates in reverse order and some other bugs #234

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago 
Which board (stock / gruvin9x / sky9x) are you using?
SKY9X REVB
What is your open9x FW version?
2XXX
What is your open9x EEPROM version?
214
What steps will reproduce the problem?
1. Try to input a model's name or mixer name or navigate through the menus with 
the use of the rotary encoder.
The ROTARY ENCODER needs to be rotated counterclockwise for incrementing the 
menu screens, ASCII input etc, it should be the opposite i think.
2. Try to input a model's name with the use of the rotary encoder 
The first rotary encoder's push always is taken as an exit command when 
performing ASCII input no matter the duration of the press, then it behaves 
like that (normal i think) short press = next letter, normal press = exit and
extended press = Capital to lower letter
3.

What is the expected output? What do you see instead?

Please provide any additional information below.

Original issue reported on code.google.com by hendri...@gmail.com on 23 Mar 2013 at 1:38

GoogleCodeExporter commented 8 years ago 
Is it reverted also when changing number values? If yes, are you sure that the 
rotary encoder is correctly wired?

Original comment by bson...@gmail.com on 3 Apr 2013 at 8:10

GoogleCodeExporter commented 8 years ago 
Hi.
Yes numbers also change in reverse order.
Well it works ok with v1965 and the rotary encoder came prewired from skyNorth
I will check to see if i can reverse it.

Original comment by hendri...@gmail.com on 3 Apr 2013 at 9:10

GoogleCodeExporter commented 8 years ago 
Perhaps first, would you check how it works with ersky9x. It's an easy change 
to make it reversed, but I would like it is easy to switch from ersky9x to 
openTx and vice / versa

Original comment by bson...@gmail.com on 3 Apr 2013 at 9:12

GoogleCodeExporter commented 8 years ago 
I just checked, it works fine with the latest ersky9x.
Chris

Original comment by hendri...@gmail.com on 3 Apr 2013 at 11:45

GoogleCodeExporter commented 8 years ago 
Ok then we are reverted. I will revert again, are you able to compile yourself?

Original comment by bson...@gmail.com on 3 Apr 2013 at 12:08

GoogleCodeExporter commented 8 years ago 
Of course
Chris

Original comment by hendri...@gmail.com on 3 Apr 2013 at 1:14

GoogleCodeExporter commented 8 years ago

Original comment by bson...@gmail.com on 3 Apr 2013 at 9:17