Turnigy 9x wont controle the receivers after Open9x upgrade

Hello,

Yesterday I received two USBasp cables and tryed to flash my stock Turnigy 9x.

first, all went bad, the first USBasp refused to read the EEPE, then I started 
the radio : she was out of service, only the backlight start, the radio doesnt 
start at all.

I tryed the second USBasp, he told me that the device id is not as expected, 
and asked me to use the -F option. As the radio was dead anyway, I used this 
option in a command line. In the begening it does not work because the 
post-flash verification was not successfull, but after some hours of tryed the 
firmware was finaly successfully writen, and the radio started with Open9X.

At first she told me that the EEPE is invalide and she formated it, I have 
access to menus etc, everything seems ok on the radio, but it wont controle any 
receiver.

First I tryed on a tricopter with the kk2 board, and on the "receiver test" 
menu, I see some strange values (143,53,53,-3) that does not change when I move 
the sticks.

I also tryed with a simple receiver + esc + 1 servo. When I connect the 
batterie, the ESC start making uninterrupted and fast biip+biip+biip+..

I tryed to calibrate the ESCs, I put the throttle at the higher position, 
connect the batterie to the esc, he make the two biips, but when I put the 
throttle in the lowest position, he don't make the 3 confirmation biips, as if 
I havent moved the throttle.

is there any option I should use in Open9x? I'm using it with default values.

Regards,

Original issue reported on code.google.com by fouadtangerois on 6 Sep 2013 at 12:19

DeBesten / opentx

Turnigy 9x wont controle the receivers after Open9x upgrade #135