display last operation position of knobs and sliders

DeBesten / opentx

Automatically exported from code.google.com/p/opentx

0 stars 0 forks source link

display last operation position of knobs and sliders #146

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago

Which board (stock / gruvin9x / sky9x / Taranis) are you using?
TARANIS
What is your openTx FW version?
r2751
What is your openTx EEPROM version?
215

Please provide any additional information below 

The main views of opentx display the current position of knobs and sliders. I 
think it would also be useful to display their last operation positions.  

For example, suppose that you use S1 to adjust wing camber on model 1. Then you 
change model and use the same potentiometer S1 to adjust wing camber on model 
2. If you fly model 1 again, you would like to easily recover your camber 
setting. This requires showing the last operation position of S1 for your 
model. I suggest the use of two marks, one on each side of the line. One would 
show the former position of the knob or slider. The other one would show the 
actual position.

Original issue reported on code.google.com by franckbe...@gmail.com on 21 Sep 2013 at 3:22

GoogleCodeExporter commented 8 years ago

Agreed. Had suggested that looong ago already:
http://code.google.com/p/open9x/issues/detail?id=172

Original comment by bernet.a...@gmail.com on 23 Sep 2013 at 2:27

Changed state: Accepted

GoogleCodeExporter commented 8 years ago

Issue 150 has been merged into this issue.

Original comment by bernet.a...@gmail.com on 28 Sep 2013 at 6:46

GoogleCodeExporter commented 8 years ago

Issue 99 has been merged into this issue.

Original comment by bernet.a...@gmail.com on 28 Sep 2013 at 6:49

GoogleCodeExporter commented 8 years ago

This would mimic the 'pseudo-sticky' behaviour of the mechanical trims on the 
MPX 4000. At startup, and when selecting a model memory, the user has to move 
the trim levers to their previous settings before the regular startup menu can 
be displayed.

Since adjusting all four pots on, say, a Taranis, may not be necessary, a nice 
refinement would be to be able to select which of the pots should treated in 
this way.

Original comment by m.shel...@gmail.com on 13 Oct 2013 at 12:00

GoogleCodeExporter commented 8 years ago

Issue 184 has been merged into this issue.

Original comment by bernet.a...@gmail.com on 20 Nov 2013 at 11:26

GoogleCodeExporter commented 8 years ago

Switch warnings can now be set individually (Issue 99) on all boards. 

Pots will follow (for ARM boards only).

Original comment by bernet.a...@gmail.com on 26 Nov 2013 at 4:15

Changed state: Started

GoogleCodeExporter commented 8 years ago

Pot position warning implemented on Taranis. 
Choice of which pots to include in the check, and auto/manual position memory 
(either set the position for each pot manually, or just store the positions at 
power off.

Original comment by bernet.a...@gmail.com on 3 Dec 2013 at 11:49

Changed state: Fixed