DeBesten / opentx

Automatically exported from code.google.com/p/opentx
0 stars 0 forks source link

Cant change to extended limits in servo page for existing model #175

Closed GoogleCodeExporter closed 8 years ago

GoogleCodeExporter commented 8 years ago
Which board (stock / gruvin9x / sky9x / Taranis) are you using?
Taranis
What is your openTx FW version?
r2834

What is your openTx EEPROM version?
215

What steps will reproduce the problem?
1.Existing model without extended limits not selected
2.Select extended limits 
3.

What is the expected output? What do you see instead?
Now Should be able to change servo limits to +/- 125.
however only able to change between +/- 100

Please provide any additional information below.

If a NEW model is created and extended limits activated as a first step then it 
is possible to get +/- 125 in servo page. 

Original issue reported on code.google.com by Peter.Ba...@gmail.com on 30 Oct 2013 at 8:44

GoogleCodeExporter commented 8 years ago
Would you attach an EEPROM and tell me which plane/which servo you tried to 
change? Also do you have PPM Center at 1500us

Original comment by bson...@gmail.com on 3 Nov 2013 at 5:39

GoogleCodeExporter commented 8 years ago
Yes extended limits can not be used on a channel where PPM center has been 
moved. It needs to be 1500.
This is likely your problem. 

Original comment by bernet.a...@gmail.com on 3 Nov 2013 at 10:59

GoogleCodeExporter commented 8 years ago
Closing this due to lack of news. Feel free to reopen if there really is an 
issue. 

Original comment by bernet.a...@gmail.com on 20 Nov 2013 at 11:34