Which board (stock / gruvin9x / sky9x / Taranis) are you using?
Taranis
What is your openTx FW version?
2647
What is your openTx EEPROM version?
dk
What steps will reproduce the problem?
1.
2.
3.
What is the expected output? What do you see instead?
Please provide any additional information below.
This is just a feature request. In multiple servo setups, like flaperons,
sometimes you have two or three mixers applied to to two channels. But often
the servos aren't mechanically identical so to correct the difference you have
to apply a correction to all the mixers multiple times. Would be much nicer if
the mixers were essentially assuming a perfect mechanical setup and the servo
setup could have a curve instead of endpoints to fix the mechanical differences
in one place.
Thanks
Original issue reported on code.google.com by mickeyno...@tmwfl.com on 25 Jul 2013 at 9:23
Original issue reported on code.google.com by
mickeyno...@tmwfl.com
on 25 Jul 2013 at 9:23