Denvi
commented
3 years ago Is the steps/mm firmware settings correct? Need "settings.ini" file from Candle folder & "$$" firmware command output.
Closed jeremylaratro closed 2 years ago
Denvi
commented
3 years ago Is the steps/mm firmware settings correct? Need "settings.ini" file from Candle folder & "$$" firmware command output.
Versions
PC info
Describe the bug I'm getting very extreme heightmap values (between -7 - +5). There are huge drops at the end of the boards, where the real difference is within a millimeter. This is on copper clad pcb board, so its nothing overtly bendable or uneven.
To Reproduce Steps to reproduce the behavior: I set the z probe, and zero the x,y, and z axes. Then I start the heightmap ( Create -> Auto -> probe). The probing works normally.
Expected behavior Heightmap with accurate values
Screenshots https://ibb.co/31rH2qB https://ibb.co/yPfKCvr