I just installed Candle 1.1.7, and I'm unable to get the jog to work properly.
I'm unable to move the stepper motors.
I can turn on the spindle however, but the steppers won't move.
When using Grbl Controller, the steppers work fine.
I sent a gcode program using Candle : works fine.
I am new to all this, what am I doing wrong ?
How can I make the arrows work ?
I just installed Candle 1.1.7, and I'm unable to get the jog to work properly. I'm unable to move the stepper motors. I can turn on the spindle however, but the steppers won't move. When using Grbl Controller, the steppers work fine. I sent a gcode program using Candle : works fine. I am new to all this, what am I doing wrong ? How can I make the arrows work ?