Closed azumimuo closed 8 months ago
sorry, it does not support android OS.
Hello again..
Since no support for Android, would you share the location of constant 3V/5V output point on-board (either than usb pin or gpio pin) power for cooling fan?
Thanks -Azumimuo-
Hi Azumimuo, You mean here ?
or you can just use the GPIO Pin which is spread out by using FFC cable to the daughter board of deskPi pro
Hi Azumimuo, You mean here ?
it's only activated only by working script (currently, no android supported script)
or you can just use the GPIO Pin which is spread out by using FFC cable to the daughter board of deskPi pro
already done that. but don't like it.
use GPIO instead of it ?
use GPIO instead of it ?
yes, not connected to the internal fan connector. there's no android supported pwm fan script for DeskPi Pro v3.
Oh , I see. yes ,it is hard to adding android support pwm fan script due to the variable version of android system. and it may need to recompile kernel or something I do not know.
hello Deskpi technical team & yoyojacky, are this unsoldered poin named "USB3" can give constant 5 volt?
why don't you use this Fan cable for 5V fan output ? or you want to use other 5v device ? you can use GPIO on back ->
Here is the pin out of USB3 soldering point. it can provide constant 5V and GND as figure showing.
Hello..
Is there any chance to have some support for Android build?
Currently, I'm successfully enable dual front USB port by adding "dtoverlay=dwc2,dr_mode=host" in /boot/config.txt and successfully boot M.2 SATA SSD from USB 3.0 port.
I'm hoping that someone could share some android script because I do not have basic programming and I do not know how to control or start the pwm fan and also add safe-cut-off power switch features.
Thanks Azumimuo