Closed JackiePease closed 4 years ago
Looking at an old photo it seems that the air assist should be attached to the top of the laser cutter head. There was a non-dusty area there too. It seems that the nut and bolt attaching the air assist had come undone. I found a new M3 nut and reattached.
New nut shown - I'll leave this issue open for the time being in case anyone is aware of other steps I need to take.
I have put an M3 nylock nut in my pocket, next time I'm in the area I'll fit it.
This came off again today, so looks like the nylock would be really useful
I'm back at the royal, so will drop in and sort this when I'm done
Sent from Yahoo Mail on Android
On Sat, 9 May 2020 at 18:33, Jackie Peasenotifications@github.com wrote:
This came off again today, so looks like the nylock would be really useful
— You are receiving this because you were assigned. Reply to this email directly, view it on GitHub, or unsubscribe.
replaced with a small hex bolt and nylock nut - should not come apart again.
Petra was laser cutting with Gerald when the air assist started dragging the piece of material across the bed.