search

DrAlexLiu / OctoPrint-PiNozCam

AI model running on RPi for failure detection
GNU Affero General Public License v3.0
39 stars 4 forks source link

Doeasn't start automatically when print starts again #31

Open febixpl opened 1 month ago

febixpl commented 1 month ago

When print is stopped and started again the PiNozzCam has OFF status. Probably it is connected to the same name of prints or temperature doesn't start from ambient temperature

DrAlexLiu commented 1 month ago

wired. Let me take a look.

Would you mind sharing the octoprint log?

febixpl commented 1 month ago

octoprint.log

febixpl commented 1 month ago

The print started at 2024-08-08 20:48:44 with AI Status: OFF. The file was upladed (again) directly from Cura and started automaticaly.

febixpl commented 1 month ago

Regarding previous attempts. I'm not sure about this but I saw AI Status: ON right after print was started but I have 7min delay. This was my second attempt, so it could be that it didn't stoped at print cancel

DrAlexLiu commented 1 month ago

OK. Please let me check.