search

DreamSourceLab / DSView

An open source multi-function instrument for everyone
www.dreamsourcelab.com
GNU General Public License v3.0
1.13k stars 416 forks source link

Decode result list - source reset after restart of program #815

Open Tobey16 opened 2 weeks ago

Tobey16 commented 2 weeks ago

After each restart of the program, decoding results will always show the results of the first decoder that is in the decoder list, regardless of what has been setup before.

dreamsource-tai commented 1 week ago

@Tobey16 Sorry, I don't quite understand what you mean.

Tobey16 commented 1 week ago

The decoder is always beeing reset to the first decoder (Timing) in the list after restarting DSView, when before another decoder was set in the decoding results list. decoding results

dreamsource-tai commented 1 week ago

@Tobey16 The decoder list above, the ones added first are listed first. The decoder list in the decoding result may not be arranged in the same order as the list above. I hope my reply can be helpful to you.

Tobey16 commented 1 week ago

No, it does not help. The issue is not resolved, as i have to set it over and over again after restarting the program.

BTW: Have you seen my other issues? (#812 - #814)

dreamsource-tai commented 1 week ago

@Tobey16 Have you tried the v1.3.2? I test this issue in my system, but it is ok.

dreamsource-tai commented 1 week ago

@Tobey16 Restarting the program will definitely reset the list, but it will only be a recollection and the list will not be affected. What I mean is the selected decoder in the decoding result.

Tobey16 commented 1 week ago

I am usind 1.3.2. I have to select UART on every start of the program, because Timing is set on every start of the program.