Pressure Advance set by job: Simulation time incorrect [RRF 3.1.1]

Duet3D / RepRapFirmware

OO C++ RepRap Firmware

GNU General Public License v3.0

943 stars 535 forks source link

Pressure Advance set by job: Simulation time incorrect [RRF 3.1.1] #435

Closed seeul8er closed 1 year ago

seeul8er commented 4 years ago

Setting the PA value in the actual print file causes the simulation time to be too low. If PA is set within the RRF config the simulated times are way more accurate. I tend to have a PA value per filament so setting the value in the job file makes sense.

Example.zip: PA 0.65

PA in .gcode file -> Sim time: 53min
PA in .config file -> Sim time 1h24min

Hardware/Software: RepRapFirmware for Duet 2 WiFi/Ethernet version 3.1.1 running on Duet WiFi 1.02 or later

michele-bertoni commented 4 years ago

What about defining PA in the config.g of your filament? You will have different PA for each filament and the simulation time should be accurate

T3P3 commented 1 year ago

Please open a forum discussion if this is still an issue in RRF 3.4.5