search

DutchDevelop / BLLEDController

Other
94 stars 26 forks source link

Status of the LEDs #15

Open goryc opened 8 months ago

goryc commented 8 months ago

I have found that, at the end of the print, the green end of print status remains lit and no longer exits this state, and I can no longer manage the white light. It would be useful to deactivate, in the P1 series, the shutdown function during plate leveling, it does not have Lidar and is not needed; while it is useful to observe the procedure better with more light!

goryc commented 8 months ago

I tried on two printers: on my P1S at the end of the print the green stays on forever; on the X1C it turns off after 5 minutes.

wile1411 commented 5 months ago

Some work on the code was recently completed by a community member Check the latest BLLC_19.3.24.bin version from official site https://www.dutchdevelop.com/bl-led-controller/

The option to have lights stay on for stages when Lidar is used is now available For a finished print, Green LEDs remain on until you open/close the door