dimming option please - Githubissues

chuckkay commented 12 months ago

i see no way to dim the lights, unless i install a dimmer dial..

the multicolr led strip i purchaced is dimmable, but BL-LED is the only controler installed.. with no instructions provided to send it commands

DutchDevelop commented 12 months ago

you'll have to be more specific about what you want. currently theres no option to dim due the controller just copies what the printer is doing

chuckkay commented 12 months ago

well i was looking for the ability to dim the light, or fingers crossed control it with alexa or some other home automation, but if you just need to stick with MQTT i think an option to access in the settings, to do the following as you currently have it that when a print finishes you change the lights to green and a few minutes later they go back to white. that must be some timing settings you put in arbitrarily, perhaps through the app let us have control over how much time to wait before going to white as long as the printer is idle, and then give us the option to set lights to go off x minutes after a completed job so long as a new job is not running.

thanks

On Mon, Sep 18, 2023 at 6:55 AM DutchDevelop @.***> wrote:

you'll have to be more specific about what you want. currently theres no option to dim due the controller just copies what the printer is doing

— Reply to this email directly, view it on GitHub https://github.com/DutchDevelop/BLLEDController/issues/6#issuecomment-1723174972, or unsubscribe https://github.com/notifications/unsubscribe-auth/ACRAHEXQVGVDSP7TOA2XGBTX3ASBJANCNFSM6AAAAAA44DJLBQ . You are receiving this because you authored the thread.Message ID: @.***>

DutchDevelop commented 10 months ago

This option has been added in the newest expirimental version

DutchDevelop / BLLEDController

dimming option please #6