Firmware upgrade for Quanum Cyclops FPV googles that adds support for manual channel selection, textual information on main screen and battery level alarm.
The battery alarm sets in to early according to this post by awap at RCGroups:
"Hi, I'm very happy with version 1.4 and the Eachine DVR installed. One whish however: I'm on a 3S battery and the beeper starts at 11.4V (3.8V per cel) and the second level beep starts at 11,2V (3,73V per cel). This is too soon. Is there a way to start the beeper at 3x3.65= 10.95 -11.0 V?"
The behavior is not really a bug, the level was set unnecessarily low.
The battery alarm sets in to early according to this post by awap at RCGroups: "Hi, I'm very happy with version 1.4 and the Eachine DVR installed. One whish however: I'm on a 3S battery and the beeper starts at 11.4V (3.8V per cel) and the second level beep starts at 11,2V (3,73V per cel). This is too soon. Is there a way to start the beeper at 3x3.65= 10.95 -11.0 V?"
The behavior is not really a bug, the level was set unnecessarily low.