The following corrections should be made to make the device function:
GAIN_SLOT should be connected with a 100k resistor to Vcc (to set gain at 3dB to avoid overloading the power supply)
The NC pads should actually be no-connects. Duh.
Currently the device outputs a somewhat modulated PWM signal (mostly correct) but the gain is set so stupidly high (12 dB) that the output just clips pretty much constantly.
The following corrections should be made to make the device function:
Currently the device outputs a somewhat modulated PWM signal (mostly correct) but the gain is set so stupidly high (12 dB) that the output just clips pretty much constantly.