Program MIX - EPA mode

[ELynx]

From https://www.youtube.com/watch?v=AhQe9XWsPlI&lc=Ugz3_b1mwtS8kJlufcR4AaABAg.A5o3jLh-JGxA5qRcD5rCbh

Look at Dumborc X6 transmitter, there is right down button CH2: EPA for throttle.
Idea Is add control end limits of Channel 2 to Channel 5 (or 6).
To set the maximum throttle during riding.
And for steering will be it good too.

[ELynx]

There is a way to make this now. To do so, use release https://github.com/ELynx/ddf-350-modding/releases/tag/v0.0.4-alpha.3 Download .ips file from there, apply it to original file (not previously patched, this is important).

Then, I set up my VR-5 as endpoint to CH2 in following way:

Map VR-5 to CH5

Set ends 100/100 on CH5. Left/lower is not that important, it can be anything, see below

Set up ProgMIX, in this case No2, to mix CH5 to 2x meaning "let CH5 be a multiplier of CH2". Important, I set REV to 0 to avoid multiplying by negative value.

So, in this configuration only half of VR-5 is used as EPA, other half just maps to zero.

I can try to make it better, but only if there is a demand and conversation. So, respond to this thread to let me know of demand for this, otherwise I will keep this as-is.

[ELynx]

Ya ya, thank you lynx for working on this, you are welcome. https://github.com/ELynx/ddf-350-modding/releases/tag/v0.0.5-alpha.1

[ELynx]

Ya ya, thank you lynx for working on this, you are welcome. https://github.com/ELynx/ddf-350-modding/releases/tag/v0.0.5-alpha.1

I don't see any positive answers to this, and actually got one to the contrary. So this is in question. I may remove this, if no one is interested.

[ELynx]

I got feedback that ⬆️ is sub-optimal solution, and I tend to agree. I will refrain from porting ⬆️ to 1.1.3, or re-opening this until I find further need.