EVA 2.1.1 makes my V6 higher than the duct (either RHD and duct 2.1).
Actual behavior
The nozzle is higher than the duct which makes impossible to print.
Expected behavior
The nozzle should be lower than the duct.
Pictures
In the picture attached you can see the nozzle and block is higher than the duct. On the duct 2.1 things get worse.
Device
Printer: V-Cast
EVA version: 2.1.1
Mods: none (original E3D V6 and Bondtech BMG)
Additional context
Changed from EVA 1.3.0 without changing V6 height or opening it. So it was a direct swap to 2.1.1.
Printed all parts from 2.1.1 stls in PETG and mounted all new parts. Removed 1.3 old parts.
Describe the bug
EVA 2.1.1 makes my V6 higher than the duct (either RHD and duct 2.1).
Actual behavior
The nozzle is higher than the duct which makes impossible to print.
Expected behavior
The nozzle should be lower than the duct.
Pictures
In the picture attached you can see the nozzle and block is higher than the duct. On the duct 2.1 things get worse.
Device
Additional context
Changed from EVA 1.3.0 without changing V6 height or opening it. So it was a direct swap to 2.1.1. Printed all parts from 2.1.1 stls in PETG and mounted all new parts. Removed 1.3 old parts.