Combined PTFE tube length (46.9mm) of LGX drive (13.8mm) and V6 hotend (33.1mm) appears to be too short. When assembling my extruder I found that ~55mm is closer to correct, with the tube passing through the LGX coupler to make contact with the body, and fully inserted into the V6 heatsink until it stops.
EVA Version
2.4.1
Which printer are you using?
V-Core 3
Terms
[X] I did seek help on Discord and found none or was instructed that this is indeed an EVA bug.
Thanks, fixed in 2.4.2, the model for LGX did not assume us shoving the PTFE so deep, I measured my LGX and made changes to the model I hope it'll be correct now.
Discord username
yolo-dubstep#8033
What happened?
Combined PTFE tube length (46.9mm) of LGX drive (13.8mm) and V6 hotend (33.1mm) appears to be too short. When assembling my extruder I found that ~55mm is closer to correct, with the tube passing through the LGX coupler to make contact with the body, and fully inserted into the V6 heatsink until it stops.
EVA Version
2.4.1
Which printer are you using?
V-Core 3
Terms