Screenshots below from PrusaSlicer. The one highlighted in green is TriHorn Duct.stl from the LGX drive page. The other two from the top are TriHorn Duct Default.stl and TriHorn Duct Wide Low.stl.
The widest LGX-sourced duct interferes with the Euclid probe, which is how I discovered the problem. The existence of the LGX-sourced duct is not an issue (some may find it useful?) but it being different from the others without commentary or being included with the others in the layer cooling section is an issue.
pkucmus
commented
2 years ago
Discord username
yolo-dubstep#8033
What happened?
Screenshots below from PrusaSlicer. The one highlighted in green is
TriHorn Duct.stlfrom the LGX drive page. The other two from the top areTriHorn Duct Default.stlandTriHorn Duct Wide Low.stl.The widest LGX-sourced duct interferes with the Euclid probe, which is how I discovered the problem. The existence of the LGX-sourced duct is not an issue (some may find it useful?) but it being different from the others without commentary or being included with the others in the layer cooling section is an issue.
EVA Version
2.4.1
Which printer are you using?
V-Core 3