search

EWU-IEEE-Spokane / squid-game-system

A system for playing red-light green-light
0 stars 0 forks source link

Draw pulleys for 3d printing #1

Open jkmunson opened 2 years ago

jkmunson commented 2 years ago

We need 2 pulley designs. The belt being used is a 3/8" V-belt. This should be a standard size.

  1. Drive pulley, for stepper motor. Stepper motor has a 5mm shaft, which should be secured against with a set screw or flat in the pulley design.
  2. Driven Pulley, to support the opposite end of the belt. Should fit ball bearings - to be measured during weekend meeting.

Once the designs are complete, commit them to /squid-game-system/pulleys

jkmunson commented 2 years ago

The diameter of the pulley TBD. probably 2 inches or so?