Ebeo / arducopter

Automatically exported from code.google.com/p/arducopter
0 stars 0 forks source link

calibrate accelerometers error #584

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago
What steps will reproduce the problem?
1.After problems with logs (see issue 583) i reset the APM2.5 and reuploaded 
the original software 2.9.1 (not b) using arduino (not MP).
2. I erased the EEPROM and went throught the configuration
3. When i tried to calibrate the accelerometers (arducopter level)
i got a message: "STABILIZE" and nothing after.

What is the expected output? What do you see instead?
When calibrating the accelerometer, you should get "place the apm level and 
press any key". I get "STABILIZE" i dont think the calibration took place.

What version of the product are you using? On what operating system?
MP1.2.46 on Windows 7 (i reinstalled mission planner to an older version 
because i didnt have logging issues then (see issue 583)).

Please provide any additional information below.
I also got the message "A_off 0.0, 0.0, 0.0 A_scale 1.00, 1.00, 1.00" instead 
of "STABILIZE", but "STABILIZE" is the most recent message.

For now i calibrate using the CLI: setup -> level, which seems to work
But i want to find out what i did wrong so i can prevent it next time.
This issue might be related to the logging issue i had. I know that by using my 
own code, some things can go wrong. But i hope you can help me.
Can you tell me or narrow down where things could have gone wrong? On what i 
should pay special attention when changing code or adding code?

Original issue reported on code.google.com by jonasv...@hotmail.com on 9 May 2013 at 4:41

GoogleCodeExporter commented 9 years ago
Closing all issues on the old issues list by marking them WontFix.

If this is still a valid issue please re-raise it on the new GitHub issues 
list: https://github.com/diydrones/ardupilot/issues

Thanks!

Original comment by rmackay...@gmail.com on 21 Jul 2013 at 2:16