Using quadrino FC do not get the four vertical sliding lines representing the four motors on my X quadcopter

Ebeo / mw-wingui

Automatically exported from code.google.com/p/mw-wingui

0 stars 0 forks source link

Using quadrino FC do not get the four vertical sliding lines representing the four motors on my X quadcopter #16

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago

What steps will reproduce the problem?
1.Happens every time I am connected
2.
3.

What is the expected output? What do you see instead?
the four vertical sliding graphs as the throttle is increased or decreased

What version of the product are you using? On what operating system?
mw-wingui 2.1 on Windows 7 64bit

Please provide any additional information below.

Original issue reported on code.google.com by jsfl...@frontier.com on 4 Aug 2012 at 11:53

GoogleCodeExporter commented 9 years ago

Are you getting readings on the Gyro/Acc chart ? If not then it is not 
connected correctly. Sometimes the first connection initates a reset on the 
board. Just Disconnect wait a couple of seconds the reconnect.

Original comment by eosba...@gmail.com on 5 Aug 2012 at 12:08

GoogleCodeExporter commented 9 years ago

Yes sir I get all the the other readings. This happens to both Quadrino FC 
boards I have. All works except the four vertical lines representing the four 
motors.

Could this be a Windows 7 x64 problem? I have loaded all the current windows 7 
upgrades and the .NET software from the download section. I am thinking because 
it does not work on either FC it must be my computer.

Thanks

Original comment by jsfl...@frontier.com on 5 Aug 2012 at 4:27

GoogleCodeExporter commented 9 years ago

[deleted comment]

GoogleCodeExporter commented 9 years ago

No answers or suggestions other than disconnect and reconnect?

everything works other than vertical lines representing motors!!

Original comment by jsfl...@frontier.com on 20 Aug 2012 at 11:59

GoogleCodeExporter commented 9 years ago

No repro

Original comment by eosba...@gmail.com on 27 Mar 2013 at 9:10

Changed state: WontFix

GoogleCodeExporter commented 9 years ago

I am having the exact same issue. Same version of wingui and windows. Did you 
ever find a fix?

Original comment by tommir...@gmail.com on 11 Apr 2014 at 4:33

GoogleCodeExporter commented 9 years ago

I found my problem was my computer because I was using a text/font size other 
than default.
As soon as I set text and font to default in windows 7 they showed up. Good 
luck, would be interested in knowing if this helps.

Original comment by jsfl...@frontier.com on 11 Apr 2014 at 6:32