glitch

[Edwin19701]

Hi I have a problem on my bushmaster a plane with ailerons and flaps with eacht wing 2 serovs to control them with switch SC up i have normal ailerons and normal flaps ons slider RS.

With Switch SC in the middle the flaps wil act like the aileron. This works oke, But when i put 2 sec slowmotion in the flaps when changing Swtch SC gifes a big Glitch on the FLAPS. Also the output shows a value and then slowley to 0 Does inybody know what is wrong?

Greeting

[pfeerick]

Without seeing your model setup, it is going to be hard to diagnose what is going on. Can you save the model to an ETX file using EdgeTX companion, and upload it here? (you'll need to change the file extension to '.zip' for the to be accepted). Otherwise, screenshots of the inputs and mixes settings may be sufficient.

[Edwin19701]

Hi Peter

Here is the file

So

Switch SC Up than the flaps are flaps

Switch SC middel the flaps become aileron

This works oke but not when the flaps are use with a slow up or down funtion.

Thanx for your time

GReeting Edwin de Geus from Holland

[pfeerick]

Sorry for the delay. You'll need to upload this on github - attachments sent via email don't work (Just drag the file into the text edit area).

[Edwin19701]

only bighorn glitch.zip

[Edwin19701]

This is the file of a Bighorn with that problem

[philmoz]

You may have already found a solution for this; but for future reference the problem occurs because slow up and down do not work correctly on mix lines that are also controlled by switches.

In your case a solution is to move the SC UP switch check from the mix line to the input line: