stale[bot]
commented
8 months ago This is a message to remind you that your request has been pending for 5 days and awaits your comments. Our agent would like to hear from you about your previous request to see if the difficulty you were facing has been resolved or if we can provide further assistance. Otherwise, if we do not hear back from you within the next three days, the issue will be closed. Kind regards, Electronic Cats Support Team
My question is in regards to the v3.1. It would appear that after loading the SerialPassThroughwithBoot that each time I plug in the CatSniffer I now have each outer blue light blinking vs when it was first sent to me I had one light blinking.
Since I now also understand the CatSniffer v3.1 came from the factory loaded with firmware (which one?) and that I've not been able to successfully load an alternate firmware due to to the inability to get bootloader mode, it would seem to me that I more then likely still have the original factory firmware on it.
So with this in mind, I thought I should maybe load back onto the RP2040 the original SerialPassThrough and return to how it was from the factory, or does that matter? There's no .uf2 file provided in the SerialPassThrough folder, but I can see the arduino directions. Is the intent to leave the SerialPassThroughwithboot loaded on the RP2040? With this loaded and two blinking lights, is the CatSniffer still ready to use with some applications in linux so long as the original firmware is still in place?