Closed EllaFoxo closed 6 months ago
There's a very narrow clearance between the toolhead sensor microswitches and an SB2040v2. Other toolhead PCBs are probably affected by this too.
To prevent shorting, I recommend we add a piece of kapton tape to the BOM, so people can opt to add it behind the toolhead PCB, should it be required.
This is up to the user to decide as there are too many different toolhead boards available. I personally have not had any clearance issues using CW2 or G2E but i also use the ebb2209.
There's a very narrow clearance between the toolhead sensor microswitches and an SB2040v2. Other toolhead PCBs are probably affected by this too.
To prevent shorting, I recommend we add a piece of kapton tape to the BOM, so people can opt to add it behind the toolhead PCB, should it be required.