The wiring instructions for the micro switch seem pretty off.
It says:
"First, solder a wire (26-28 AWG
recommended) to the Normally Closed
(NC) leg of each microswitch, matching
the length for each gate to the table to
the left. Last (N) is gate closest to the
MMB,
Next, connect the Common (C) legs of
each neighboring switch with a piece of
wire 70mm long.
For the last microswitch in the chain,
solder an additional 110mm wire to the
Common leg, to feed to the MCU."
The Last gate isn't N its N-1, since we start counting at 0.
Also the table with wire lengths should be N- and not N+ since we are counting down and not up.
The wiring instructions for the micro switch seem pretty off.
It says: "First, solder a wire (26-28 AWG recommended) to the Normally Closed (NC) leg of each microswitch, matching the length for each gate to the table to the left. Last (N) is gate closest to the MMB, Next, connect the Common (C) legs of each neighboring switch with a piece of wire 70mm long. For the last microswitch in the chain, solder an additional 110mm wire to the Common leg, to feed to the MCU."
The Last gate isn't N its N-1, since we start counting at 0. Also the table with wire lengths should be N- and not N+ since we are counting down and not up.