Please omit DM5 bit state translation from DM5 heartbeat messages

[ericthomasswenson]

Please omit DM5 bit state translation from DM5 heartbeat message replies. These are shown in the italicized text below. Translations for DM5 queries in test steps shall remain.

10:45:01.8170 Global DM5 Heartbeat Request 10:45:01.8200 18EAFFF9 [3] CE FE 00 (TX) 10:45:01.8285 18FECE03 [8] 00 00 05 00 00 00 00 00 DM5 from Transmission #1 (3): OBD Compliance: Not intended to meet OBD II requirements (5), Active Codes: 0, Previously Active Codes: 0 Continuously Monitored System Support/Status: Comprehensive component not supported, complete Fuel System not supported, complete Misfire not supported, complete Non-continuously Monitored System Support/Status: A/C system refrigerant not supported, complete Boost pressure control sys not supported, complete Catalyst not supported, complete Cold start aid system not supported, complete Diesel Particulate Filter not supported, complete EGR/VVT system not supported, complete Evaporative system not supported, complete Exhaust Gas Sensor not supported, complete Exhaust Gas Sensor heater not supported, complete Heated catalyst not supported, complete NMHC converting catalyst not supported, complete NOx catalyst/adsorber not supported, complete Secondary air system not supported, complete // May the DM5 translations for heartbeat messages be skipped. They aren’t evaluated. // The translations add dozens of pages to the length of the report.

[anthonyhbest]

The heartbeats are not translated in v3.1.19