ErikDeBruijn ReplicatorG-Erik5D issues

ErikDeBruijn / ReplicatorG-Erik5D

An open-source gcode interpreter for driving RepRaps, Makerbots, and other similar CNC beasties

http://replicat.org

GNU General Public License v2.0

16 stars 1 forks source link

issues

Newest

Newest Most commented Recently updated Oldest Least commented Least recently updated

Incomplete files are not being detected

#18 ErikDeBruijn opened 12 years ago
0
Manual extrude: motor rpm + pwm are misnomers for RepRaps

#17 D1plo1d opened 13 years ago
0
manual extrude: reverse does not reverse, only goes forward

#16 D1plo1d closed 13 years ago
2
RepRap cannot reconnect after power cycling

#15 D1plo1d opened 13 years ago
0
Manual extrude is slugish in updating extruder rate

#14 D1plo1d closed 13 years ago
1
Manual extrude almost completely freezes gui

#13 D1plo1d closed 13 years ago
1
Handle uppercase "Start" as well... (in the reprap5d driver)

#12 ErikDeBruijn opened 13 years ago
0
Handle safety interruption informatively: temperature sensor safety trigger

#11 ErikDeBruijn opened 13 years ago
0
Handle safety stops informatively: Z-limit endstop trigger

#10 ErikDeBruijn opened 13 years ago
0
Warning and Z-limit switch

#9 ErikDeBruijn opened 13 years ago
0
Build volume mismatch

#8 ErikDeBruijn opened 13 years ago
1
RepRap firmware builds

#7 D1plo1d opened 13 years ago
1
Build volume in stl preview should correspond to machines.xml entries

#6 ErikDeBruijn closed 13 years ago
1
Receive temperatures correctly

#5 ErikDeBruijn closed 13 years ago
0
SD card upload

#4 ErikDeBruijn opened 13 years ago
2
Make acceleration a software configurable setting

#3 ErikDeBruijn opened 13 years ago
0
Checksums and retransmits

#2 ErikDeBruijn closed 13 years ago
8
ONLY USE THIS FOR RepRap5D and ULTIMAKER SPECIFIC ISSUES!

#1 ErikDeBruijn opened 13 years ago
0