Video output is shown even if experimental features are not enabled

Esri / Trek2There

Trek2There™

Apache License 2.0

10 stars 5 forks source link

Video output is shown even if experimental features are not enabled #70

Closed dominikargast closed 6 years ago

dominikargast commented 6 years ago

Make sure "use experimental features" in the settings page is not checked. Holding the phone upright, the video output stream is shown briefly, before being faded out again. The location marker and VR arrow on green ground are not displayed.

dominikargast commented 6 years ago

@marikavertzonis test with 3.0.5

marikavertzonis commented 6 years ago

on 3.0.5 on iphone 8 and trimble tdc (android 6) i see strange behaviour with the camera. to consistently repro:

go to settings page and enable experimental mode
go back to main page, see that when you tilt the device you get the camera view as expected when vertical
go back to settings page and disable experimental mode
go back to main page, see that camera mode is always enabled.

NB: on the iphone i didn’t need to enable experimental mode for this permanent camera behaviour - it happened when i did a fresh install and launch the app

dominikargast commented 6 years ago

@marikavertzonis test with 3.0.6

marikavertzonis commented 6 years ago

with 3.0.6 on

iphone 8 (ios 11.2.5)
trimble tdc100 (android 6)
nexus 7 (android 7)
windows 10 with classic x86 installer

very smooth transitions between horizontal (standard arrow view) and vertical (camera view) holding position of the device/app.

windows phone and windows desktop using UWP build - i get no camera view when in experimental mode. this issue now specifically for UWP. the app doesn't crash, and i showed @shobanasuresh and she thinks its more likely to do with something in the tilt detection not being handled in UWP rather than the camera preview itself.