Open ericweiner opened 2 months ago
(v 2.1.0 but think this has always been true...)
In the settings/current JSON, the XY bookmarks are:
"bookmark": { "x": 50000.0, "y": 75000.0, "z": 4950.0
These are in mm, not microns, so these numbers are not good, you just go off the edge of the plate.
We should probably just set it to A1 on a 96well plate, as the initial default. x = 14.38, y= 11.24 mm I think the Z is probably ok...
(v 2.1.0 but think this has always been true...)
In the settings/current JSON, the XY bookmarks are:
"bookmark": { "x": 50000.0, "y": 75000.0, "z": 4950.0
These are in mm, not microns, so these numbers are not good, you just go off the edge of the plate.
We should probably just set it to A1 on a 96well plate, as the initial default. x = 14.38, y= 11.24 mm I think the Z is probably ok...