search

ExpressLRS / ExpressLRS-Hardware

STM32/ESP32/ESP8285-based High-Performance Radio Link for RC applications
248 stars 98 forks source link

TX_SX1280_Slimmer PCB doesn't fit SugarK "slimmer" case #6

Closed joymonkey closed 2 years ago

joymonkey commented 3 years ago

I printed SugarK's case STL's for the TX_SX1280_Slimmer PCB, but no matter what way I try to fit the assembled PCB, I can't get the lid to fit. If oriented with the regulator on top (which I think is the better way of assembling), the regulator prevents the lid from fitting. If oriented with the ESP32 and E28 on top, those modules also prevent the lid from fitting. The lid may need to be adjusted so more space is permitted for the regulator. I mounted the regulator relatively flush with the PCB surface (just a layer of electrical tape between them), and the regulator protrudes 2mm above the case. PXL_20210609_173001854

AaryanL commented 2 years ago

this is not hw problem but SugarK's design i think you should contact him about this, not elrs issues thread