Holiday Mode Doesn't Stay Active on Cascaded Ecodan

F1p / Home-Assistant-Mitsubishi-Ecodan-CN105-to-MQTT

Originally based on the CN105 decode by m000c400, this fork provides CN105 control from basic microcontrollers like the ESP8266 or ESP32

7 stars 1 forks source link

Holiday Mode Doesn't Stay Active on Cascaded Ecodan #5

Open drnichols opened 1 month ago

drnichols commented 1 month ago

Hi @F1p, not sure if this is just an Ecodan cascade oddity...when I enable holiday mode it stays on for a few seconds before automatically reverting to disabled. It does the same from the main controller so it may well be a cascade 'feature'. Holiday mode worked ok when my systems were standalone. My systems are all running different FW which could also be a factor (I'm hoping to get them updated to the same version). Any thoughts or debugging I can do?

F1p commented 1 month ago

I found my FTC5 actually does the same, it does latch but then quickly unlatches (on the screen) - i wondered if it was my FTC firmware Not every time though i might note...

drnichols commented 1 month ago

@F1p I'm experimenting with server control now which I think will replace the Holiday Mode for me going forwards, plus opens up many more automation options. Nice work!