search

FAU2016-ED1Group8 / SS-Hardhat

0 stars 1 forks source link

Dremel and sand 3D prints #107

Closed agoich closed 7 years ago

fpsoares commented 7 years ago

Look into acetone bath for smooth finish of the print, I tried using a dremmel to sand down pieces and it is very easy to ruin it. Another possibility is just heating it up with a heat gun, also, be careful to not collapse internal structure (also had it happen to me)

agoich commented 7 years ago

I'll run it by you first before I do anything

On Thu, Mar 23, 2017 at 10:24 PM, Felipe Soares notifications@github.com wrote:

Look into acetone bath for smooth finish of the print, I tried using a dremmel to sand down pieces and it is very easy to ruin it. Another possibility is just heating it up with a heat gun, also, be careful to not collapse internal structure (also had it happen to me)

— You are receiving this because you were assigned. Reply to this email directly, view it on GitHub https://github.com/FAU2016-ED1Group8/SS-Hardhat/issues/107#issuecomment-288915713, or mute the thread https://github.com/notifications/unsubscribe-auth/AV967yLq33eDB7iG5tyAgyujMVXwFdohks5royl3gaJpZM4MnldL .