search

FPV-Combat / Main_board_v2

Firmware and documentation for FPV-combat main board HW versions 2.x
6 stars 0 forks source link

Is it possible to have OSD with DJI AirUnit o3 and Googles 2? #49

Open feffe81 opened 6 months ago

ysoldak commented 6 months ago

Yes, DJI O3 Air Unit works. Please flash latest firmware, it is 2.7.0-B5 now.

See firmware flash instructions (a bit low level, we'll have Configurator/Flasher UI soon) https://github.com/FPV-Combat/Main_board_v2/wiki/Flash-Firmware

feffe81 commented 6 months ago

Nice. I have not found any documentation how to wire it up. Is there something available?

Gruß Steffen

ysoldak commented 6 months ago

You connect O3 and combat board same as you would connect it to a flight controller.

On the combat board (hardware version 2.6, latest) there are MSP pins. Connect O3 RX to combat board MSP TX and O3 TX to combat board MSP RX.

feffe81 commented 6 months ago

Thx

feffe81 commented 6 months ago

Is there any documentation or source code available for MSP with O3? I would also like to include it in my project on GitHub

ysoldak commented 6 months ago

Is there any documentation or source code available for MSP with O3? I would also like to include it in my project on GitHub

No, sorry, no our code available. But look here, you may find this useful https://github.com/ramiss/arduino_DJI_03_RC_ARM