FYSETC Board - The E4 board is a minimal 3D printer control board based on the ESP32 microcontroller from ESPRESSIF, with built-in Wi-Fi and Bluetooth.
Ist planed to support Klipper Firmware with the E4 board and ESP32 chip.
Is somebody working on that?
Also is it planned to have web interface Mainsail run on the board as well without using an Raspberry pi.
Hi,
Ist planed to support Klipper Firmware with the E4 board and ESP32 chip. Is somebody working on that? Also is it planned to have web interface Mainsail run on the board as well without using an Raspberry pi.
Greetings Ixman