FYSETC Board - The E4 board is a minimal 3D printer control board based on the ESP32 microcontroller from ESPRESSIF, with built-in Wi-Fi and Bluetooth.
The PDF schematic in this repo specifies the drivers' current sense resistors as 0.22R. However, the actual board I received has 0.11R resistors, which are the typical value used for these drivers.
Same here, I was looking everywhere for the 0.22R resistors (I have also 0.11R instead) on the board and I think it's probably a mistake in the pdf schematic.
The PDF schematic in this repo specifies the drivers' current sense resistors as 0.22R. However, the actual board I received has 0.11R resistors, which are the typical value used for these drivers.