STM32CubeProgrammer won't flash bootloader

FYSETC / FYSETC-SPIDER

FYSETC Board - 3d printer motherboard for VORON and other open source project.

310 stars 148 forks source link

STM32CubeProgrammer won't flash bootloader #102

Open TinkerBridget opened 2 years ago

TinkerBridget commented 2 years ago

14:48:38 : Time elapsed during the read operation is: 00:00:00.031 14:48:45 : Memory Programming ... 14:48:45 : Opening and parsing file: Bootloader_FYSETC_SPIDER.hex 14:48:45 : Error: Parsing fail 14:48:45 : Error: In line 38 : 14:48:45 : Error: parsing count, expecting hex digit, found ' '

Not sure what the problem is here, but I will add it to the list of issues. I just wanted to reflash with a newly generated klipper firmware to make sure that wasn't the problem and I can't seem to do it.

TinkerBridget commented 2 years ago

I ended up not using the bootloader, compiled an updated klipper firmware and flashed it from my PC rather than using the SD card.

Board works, but it should have been possible to reflash the provided bootloader to it.

Meffesino commented 1 year ago

I have got the same problem. I'm not able to use STM32CubeProgramming to flash the latest 32bit Bootloader.

ataman78 commented 1 year ago

Problem is 100% in your .hex. You must download not only .hex by "save as" but a whole project in zip. Then will work. Good luck)

Terecon commented 1 year ago

Проблема на 100% в вашем .hex. Вы должны скачать не только .hex с помощью «сохранить как», но и весь проект в zip. Тогда будет работать. Удачи) Я прошивал не один раз, но сейчас не работает. Посмотрите видео. Что не так. https://disk.yandex.ru/i/E_vNhVVvQbynjg