I have a setup of a voron 2.4, pi zero 2 with mainsail/klipper and a spider 2.3. My plan was to connect it via UART. Ive gone through every guide or instruction I can find online on how to set it up but it just seems like a struggle.
the Raspberry doesnt seem to recognize the board even though I have uploaded/flashed the firmware onto the spider via sd-card.
I tried to connect the card to the computer to STM32cubeprogrammer but its not being recognized. But when I run "lsusb", I can see the input as a DFU.
all the lights on the board seems to do work fine, just no/little sign of life from the mcu.
I have a setup of a voron 2.4, pi zero 2 with mainsail/klipper and a spider 2.3. My plan was to connect it via UART. Ive gone through every guide or instruction I can find online on how to set it up but it just seems like a struggle. the Raspberry doesnt seem to recognize the board even though I have uploaded/flashed the firmware onto the spider via sd-card.
I tried to connect the card to the computer to STM32cubeprogrammer but its not being recognized. But when I run "lsusb", I can see the input as a DFU.
all the lights on the board seems to do work fine, just no/little sign of life from the mcu.
Any ideas?