Spider v2.3; USB problems; no MCU id.

FYSETC / FYSETC-SPIDER

FYSETC Board - 3d printer motherboard for VORON and other open source project.

310 stars 148 forks source link

Spider v2.3; USB problems; no MCU id. #150

Open Fickert07 opened 7 months ago

Fickert07 commented 7 months ago

Able to flash bootloader and firmware via USB with STM32 Programmer, additionally able to flash firmware Via SD (confirmed with old.bin file on sd card after install), but Pi does not detect a USB change with sudo dmesg when I unplug and plug back in the board.

Pi is not the issue as it is detecting multiple Webcams via USB.

Not sure where to go from here other than order a new board. Frustrating as I purchased a year ago, but was never taken out of the plastic.

Any tips I will be greatful.

Fickert07 commented 7 months ago

Also to add, firmware compiled was using USB not serial or CAN.

zhujue888 commented 7 months ago

看来没有得到任何回复。