search

FYSETC / FYSETC-SPIDER

FYSETC Board - 3d printer motherboard for VORON and other open source project.
310 stars 148 forks source link

Spider 3 with TMC2209 V4.0 (fysetc) stepper drivers #155

Open ozzman39 opened 4 months ago

ozzman39 commented 4 months ago

TMC2209 V4.0 spider v3.0

I am getting Unable to read tmc uart 'stepper_x' register IFCNT I have tried 2 diffrent jumper configs off the wireing diagram 1 on the PDN pin

also tried all 4 if i use all 4 i get Unable to read tmc uart 'stepper_x' register IFCNT

thease are the stepper drivers i have https://www.amazon.com/dp/B08M9J8SB7?psc=1&ref=ppx_yo2ov_dt_b_product_details

I could not find v3.1 so i opted for the 4.0 image-2

as you can see in the pic from a fysetc video it looks like the 4.0 work on the spider 3

ozzman39 commented 4 months ago

Just tried switching the stepper driver in that slot thinking maybe I had a bad one same error.

ozzman39 commented 4 months ago

what are the chances of 2 stepper driver slots being dead on a board? getting (Unable to read tmc uart 'stepper_(X andY)' register IFCNT) if i move the steppers over to the end of the board it I can clear the error (s). the pinout looks correct (github and photo) Spider 3 PXL_20240421_212427697 MP

eliwong commented 4 months ago

image I'm very sorry that the video is wrong and bothered you. The power supply next to XY is prepared for 48V. If you do not use 48V, you need to short-circuit 24V and 48V so that the XY socket will have power. Both 2209 V3.1 and V4.0 can be used on PSIDER 3.0. All it takes is a jumper cap.

ozzman39 commented 4 months ago

Thanks !! this resolved my issue !!