I am trying to connect the BTT Microprobe with Spider v1.0, I am using the Z Max and Min headers with the VProbe set to 5V. When it is connected to the ZMax port the board doesn't turn on at all and the probe does nothing, the 12v and 3.3v lights are turned off and only 24v light is on. If I use another 5V port to power the probe, it works for the probe to do it's self test, all the 24/12/3.3v lights are on. But a few seconds later the 12/3.3v lights turn off and it is the same thing. I don't think it should be drawing too much power, it only uses 350ma, so I am not sure what is going wrong.
I am trying to connect the BTT Microprobe with Spider v1.0, I am using the Z Max and Min headers with the VProbe set to 5V. When it is connected to the ZMax port the board doesn't turn on at all and the probe does nothing, the 12v and 3.3v lights are turned off and only 24v light is on. If I use another 5V port to power the probe, it works for the probe to do it's self test, all the 24/12/3.3v lights are on. But a few seconds later the 12/3.3v lights turn off and it is the same thing. I don't think it should be drawing too much power, it only uses 350ma, so I am not sure what is going wrong.