I am upgrading an old Creality Ender 5 Plus default Creality v2.2 board to the FYSETC Spider v2.2, and so far I have had a good result rewiring and flashing, but the Raspberry Pi only detects the MCU in DFU mode, and then if I remove the 3.3v and 5V jumpers to switch back to normal operation, the USB cannot be found no matter what I do.
I have used multiple USB cables and all of them have failed to get me a USB connection. lsusb shows no new USB, and sudo dmesg shows no connected USB.
Just to make sure I am doing this correctly... if I am using a Raspberry Pi over USB, I do not need ANY JUMPERS connected at all?
Nothing from BT0 to GND, or any other jumper in the power areas?
I am upgrading an old Creality Ender 5 Plus default Creality v2.2 board to the FYSETC Spider v2.2, and so far I have had a good result rewiring and flashing, but the Raspberry Pi only detects the MCU in DFU mode, and then if I remove the 3.3v and 5V jumpers to switch back to normal operation, the USB cannot be found no matter what I do.
I have used multiple USB cables and all of them have failed to get me a USB connection.
lsusbshows no new USB, andsudo dmesgshows no connected USB.Just to make sure I am doing this correctly... if I am using a Raspberry Pi over USB, I do not need ANY JUMPERS connected at all?
Nothing from BT0 to GND, or any other jumper in the power areas?