I have a Fysetc Spider 1.1 with TMC2209. Using Klipper and trying to homing the dual carriage. The X1 motor that is connected to X-MOT with diag pin PB14 works fine with the sensorless, the X2 motor is connected on the E0-MOT with diag pin PA1 and doesn't stop, and also doesn't obbey to the command SET_TMC_FIELD
klippy.log
STEPPER=dual_carriage FIELD=SGTHRS VALUE=255, if I make a G28 X0 this motor always move, and if i change the diag my endstop is always active. Any solution for this?
Hello,
I have a Fysetc Spider 1.1 with TMC2209. Using Klipper and trying to homing the dual carriage. The X1 motor that is connected to X-MOT with diag pin PB14 works fine with the sensorless, the X2 motor is connected on the E0-MOT with diag pin PA1 and doesn't stop, and also doesn't obbey to the command SET_TMC_FIELD klippy.log STEPPER=dual_carriage FIELD=SGTHRS VALUE=255, if I make a G28 X0 this motor always move, and if i change the diag my endstop is always active. Any solution for this?