I was printing an object when all of a sudden bed heat started to drop. Bed heater error was displayed and the red 'Flash' LED lit on the Spider board, Tried to reflash the board, it was successful but the once the jumper was removed and powered back on it can not connect to the spider board. Using USB Serail connection. This was printing very well up to this point. It is a FYSETC Voron 2.4 kit, built and tested though the voron build documentation. Nothing out of the ordinary going on it was sprinting normally, 30 minutes into a 2hour print job. No changes have been made recently.
I was printing an object when all of a sudden bed heat started to drop. Bed heater error was displayed and the red 'Flash' LED lit on the Spider board, Tried to reflash the board, it was successful but the once the jumper was removed and powered back on it can not connect to the spider board. Using USB Serail connection. This was printing very well up to this point. It is a FYSETC Voron 2.4 kit, built and tested though the voron build documentation. Nothing out of the ordinary going on it was sprinting normally, 30 minutes into a 2hour print job. No changes have been made recently.