Open Trytas opened 2 years ago
I now tried the "STEPPER_BUZZ STEPPER=stepper_x" Command in the console for all motors.
All 4 Z-Stepper and the Extruder are running without issues, but the Error is coming up for both gantry Steppers.
So not only the X but also the Y-Stepper.
I have the same problem, were you able to solve it?
Yes I was able to solve it. It was in my case I didn't bridge the 24V and 48V on the right side of the Spider 2.2 Board. It wasn't mentioned anywhere and I got told about it in the Voron Discord.
Could you show how you done it? I have the same problem but that big black jumper is installed
Try this : https://github.com/FYSETC/FYSETC-SPIDER#52-tmc2209-connection-issue
Isn't that for TMC2209 v3.0? v3.1 has different pin location.
Hi,
I'm at the moment trying to get my Voron running. I've got the Spider v2.2 with 7 TMC 2209 v3.1 drivers installed.
I installed every jumper as shown in the instruction. I Already tried to switch the cables to the steppers and also switch the drivers.
My next try is pulling my 2208s out of my CR-10 as soon as it has finished the print.
Here is my Config. I just converted the .cfg to .txt config.txt